Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR(for Rear Side) › from 2014.03
RM30M0E _59 Vehicle Exterior _017125 WIPER / WASHER _0116752 WASHER MOTOR(for Rear Side) G

WIPER / WASHER  WASHER MOTOR(for Rear Side)  INSPECTION  


PROCEDURE

Hide 85330F 1.INSPECT REAR WASHER MOTOR AND PUMP ASSEMBLY

a.

Remove the washer jar.


b.

Disconnect the rear washer motor and pump assembly connector.

HINT:

The check should be performed with the rear washer motor and pump assembly installed on the washer jar.



c.

Fill the washer jar with washer fluid.


d.
E140350
0.073,0.063 0.354,0.313 0.281,0.25 10 false *a
*a Component without harness connected
(Rear Washer Motor and Pump Assembly)


Connect a battery positive (+) lead to terminal 1 of the rear washer motor and pump assembly, and a negative (-) lead to terminal 2.


e.

Check that washer fluid flows from the washer jar.

OK:

Washer fluid flows from the washer jar.


If the result is not as specified, replace the rear washer motor and pump assembly.