75741E
1.REMOVE SYMBOL EMBLEM
75441E
2.REMOVE NO. 1 BACK DOOR NAME PLATE (w/ Brand Mark)
75442A
3.REMOVE NO. 2 BACK DOOR NAME PLATE
75443
4.REMOVE NO. 3 BACK DOOR NAME PLATE (w/ Engine Displacement Mark)
75444
5.REMOVE NO. 4 LUGGAGE COMPARTMENT DOOR PLATE (w/ Grade Mark)
85345R
6.REMOVE REAR WASHER NOZZLE
85292A
7.REMOVE REAR WIPER ARM HEAD CAP
8.REMOVE REAR WIPER ARM AND BLADE ASSEMBLY
85143R
9.REMOVE REAR WIPER MOTOR GROMMET
74811B
10.REMOVE DOOR PULL HANDLE
Disengage the 4 claws and remove the door pull handle.
67005B
11.REMOVE BACK DOOR PANEL CUSHION
Use the same procedure for both sides.
Remove the back door panel cushion.
67751
12.REMOVE BACK DOOR TRIM BOARD
Using a clip remover, remove the 9 clips and the back door trim board.
899A0B
13.REMOVE NO. 3 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (w/ Smart Entry and Start System)
67754G
14.REMOVE BACK DOOR TRIM SPACER
Using a clip remover, disengage the 3 clips and remove the back door trim spacer.
85110R
15.REMOVE REAR WIPER MOTOR ASSEMBLY
69350
16.REMOVE BACK DOOR LOCK ASSEMBLY (w/ Wireless Door Lock System)
69350
17.REMOVE BACK DOOR LOCK ASSEMBLY (w/o Wireless Door Lock System)
18.REMOVE BACK DOOR LOCK CYLINDER ASSEMBLY (w/o Wireless Door Lock System)
Remove the 2 nuts and the back door lock cylinder assembly.
69790
19.REMOVE BACK DOOR LOCK CONTROL ASSEMBLY (w/o Wireless Door Lock System)
Remove the 2 nuts and the back door lock control assembly.
76801A
20.REMOVE LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY (w/ Wireless Door Lock System)
76801A
21.REMOVE LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY (w/o Wireless Door Lock System)
84840G
22.REMOVE BACK DOOR OPENER SWITCH ASSEMBLY (w/ Wireless Door Lock System)
69023
23.REMOVE BACK DOOR OUTSIDE HANDLE SUB-ASSEMBLY (w/o Wireless Door Lock System)
Remove the back door outside handle sub-assembly from the luggage compartment door outside garnish sub-assembly.
81270
24.REMOVE LICENSE PLATE LIGHT ASSEMBLY
81952D
25.REMOVE REAR LIGHT COVER
81977
26.REMOVE CENTER STOP LIGHT COVER
81570
27.REMOVE CENTER STOP LIGHT ASSEMBLY
82185
28.REMOVE NO. 2 BACK DOOR WIRE
Disconnect the 2 connectors.
Using a clip remover, disengage the 5 clamps and remove the No. 2 back door wire.