Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR OPENER SWITCH › from 2014.03
RM30M0E _59 Vehicle Exterior _017122 DOOR / HATCH _0116783 BACK DOOR OPENER SWITCH G

DOOR / HATCH  BACK DOOR OPENER SWITCH  INSPECTION  


PROCEDURE

Hide 84840G 1.INSPECT BACK DOOR OPENER SWITCH ASSEMBLY (w/ Smart Entry and Start System)

a.
B348633
0.938,0.906 1.333,1.333 true 2.427,0.896 2.083,1.333 true 1.448,3.615 1.104,4.052 true 1.719,3.625 1.719,4.042 true 1.99,3.583 2.219,4.021 true 0.51,2.531 0.823,2.688 0.313,0.156 10 false *a 0.75,0.792 1.063,0.948 0.313,0.156 10 false *b 2.458,0.76 2.771,0.917 0.313,0.156 10 false *c 0.958,4.083 1.208,4.333 0.25,0.25 10 false UL 1.698,4.083 1.948,4.333 0.25,0.25 10 false E 2.25,4.083 2.5,4.333 0.25,0.25 10 false L
*a Component without harness connected
(Back Door Opener Switch Assembly)
*b Open Switch
*c Lock Switch


Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 (L) - 2 (E) Open Switch Pushed Below 1 Ω
1 (L) - 2 (E) Open Switch Not Pushed 10 kΩ or higher
2 (E) - 3 (UL) Lock Switch Pushed Below 1 Ω
2 (E) - 3 (UL) Lock Switch Not Pushed 10 kΩ or higher


If the result is not as specified, replace the back door opener switch assembly.



Hide 84840G 2.INSPECT BACK DOOR OPENER SWITCH ASSEMBLY (w/o Smart Entry and Start System)

a.
B348634
1.385,1.302 1.802,0.885 true 1.219,4.094 1.479,3.594 true 1.719,4.115 1.719,3.615 true 0.469,2.51 0.781,2.667 0.313,0.156 10 false *a 1.854,0.75 2.167,0.906 0.313,0.156 10 false *b 1.021,4.167 1.333,4.365 0.313,0.198 10 false UL 1.688,4.167 2,4.365 0.313,0.198 10 false E
*a Component without harness connected
(Back Door Opener Switch Assembly)
*b Open Switch


Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
2 (E) - 3 (UL) Open Switch Pushed Below 1 Ω
2 (E) - 3 (UL) Open Switch Not Pushed 10 kΩ or higher


If the result is not as specified, replace the back door opener switch assembly.