Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR SEAT ASSEMBLY (for Separate Seat Type)
2.REMOVE REAR SEAT ASSEMBLY (for Fold Down Seat Type)
64330
3.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY
64711E
4.REMOVE LUGGAGE COMPARTMENT FLOOR MAT
58410B
5.REMOVE DECK BOARD ASSEMBLY
64772
6.REMOVE SPARE WHEEL COVER PAD
64773B
7.REMOVE NO. 2 SPARE WHEEL COVER PAD
64716D
8.REMOVE REAR DECK TRIM COVER
64740C
9.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
Using a clip remover, remove the 7 clips and deck trim side panel assembly LH.
10.REMOVE REAR WHEEL
48540
11.REMOVE REAR SHOCK ABSORBER ASSEMBLY
| *a | Wooden Block |
| *b | Jack |
Support the rear axle beam assembly with a jack. Insert a wooden block between the jack and rear axle spring seat to prevent damage.
Keep supporting the rear axle beam assembly with a jack until the installation of the rear shock absorber assembly is complete.
| *a | Turn |
| *b | Hold |
While holding the rear shock absorber piston rod, remove the 2 nuts.
Remove the rear shock absorber cushion retainer and rear suspension support.
Remove the bolt and rear shock absorber assembly from the rear axle beam assembly.
48752A
12.REMOVE REAR SUSPENSION SUPPORT STOPPER
Remove the rear suspension support stopper from the rear shock absorber assembly.
48760B
13.REMOVE REAR SUSPENSION SUPPORT ASSEMBLY
Remove the rear suspension support assembly from the rear shock absorber assembly.