52021
1.INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY (for LHD)
Install the front bumper reinforcement sub-assembly with the 5 nuts.
Engage the 4 clamps and install the wire harness.
52021
2.INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY (for RHD)
Install the front bumper reinforcement sub-assembly with the 5 nuts.
Engage the 3 clamps and install the wire harness.
53288B
3.INSTALL RADIATOR SUPPORT EXTENSION LH
Engage the 2 claws and install the radiator support extension LH.
Install the clip.
53287B
4.INSTALL RADIATOR SUPPORT EXTENSION RH
Use the same procedure as for the LH side.
52611
5.INSTALL FRONT BUMPER ENERGY ABSORBER (w/ Energy Absorber)
Engage the 2 guides and install the front bumper energy absorber.
53286B
6.INSTALL NO. 2 RADIATOR SIDE AIR SEAL (w/ Energy Absorber)
Engage the 2 claws and install the No. 2 radiator side air seal.
w/ Projector Headlight:
Install the clip.
Connect the connector.
Engage the clamp and install the wire harness.
w/o Projector Headlight:
Install the clip.
Connect the 2 connectors.
Engage the clamp and install the wire harness.
53285B
7.INSTALL NO. 1 RADIATOR SIDE AIR SEAL (w/ Energy Absorber)
Use the same procedure as for the No. 2 radiator side air seal side.
53286B
8.INSTALL NO. 2 RADIATOR SIDE AIR SEAL (w/o Energy Absorber)
Engage the 3 claws and install the No. 2 radiator side air seal.
w/ Projector Headlight:
Install the clip.
Connect the connector.
Engage the clamp and install the wire harness.
w/o Projector Headlight:
Install the clip.
Connect the 2 connectors.
Engage the clamp and install the wire harness.
53285B
9.INSTALL NO. 1 RADIATOR SIDE AIR SEAL (w/o Energy Absorber)
Use the same procedure as for the No. 2 radiator side air seal.
88790B
10.INSTALL THERMISTOR ASSEMBLY (for Air Conditioning)
88891H
11.INSTALL NO. 1 COOLER COVER (w/ No. 1 Cooler Cover)
Engage the 2 guides and install the No. 1 cooler cover.
Install the 2 clips.
52536
12.INSTALL FRONT BUMPER SIDE RETAINER LH
Engage the 2 claws and install the front bumper side retainer LH.
Install the bolt and screw.
52535
13.INSTALL FRONT BUMPER SIDE RETAINER RH
Use the same procedure as for the LH side.
52128B
14.INSTALL FRONT BUMPER HOLE COVER LH (w/ Fog Light)
Engage the 7 claws and install the front bumper hole cover LH.
52127D
15.INSTALL FRONT BUMPER HOLE COVER RH (w/ Fog Light)
Use the same procedure as for the LH side.
52128B
16.INSTALL FRONT BUMPER HOLE COVER LH (w/o Fog Light)
Engage the 7 claws and install the front bumper hole cover LH.
52127D
17.INSTALL FRONT BUMPER HOLE COVER RH (w/o Fog Light)
Use the same procedure as for the LH side.
81220
18.INSTALL FOG LIGHT ASSEMBLY LH (w/ Fog Light)
Engage the guide and install the fog light assembly LH with the 2 screws.
81210A
19.INSTALL FOG LIGHT ASSEMBLY RH (w/ Fog Light)
Use the same procedure as for the LH side.
53112E
20.INSTALL LOWER NO. 1 RADIATOR GRILLE
Engage the 21 claws and install the lower No. 1 radiator grille.
52113
21.INSTALL FRONT BUMPER BAR LH
Engage the 4 claws and install the front bumper bar LH.
52112
22.INSTALL FRONT BUMPER BAR RH
Use the same procedure as for the LH side.
52127C
23.INSTALL FRONT BUMPER HOLE COVER
Engage the claw.
Engage the 3 claws and guide, and install the front bumper hole cover.
75311
24.INSTALL RADIATOR GRILLE (OR FRONT PANEL) EMBLEM
Engage the 3 claws and 2 guides, and install the radiator grille (or front panel) emblem.
25.INSTALL GROMMET
Install the 4 grommets.
53879A
26.INSTALL FRONT FENDER LINER RETAINER
Install the front fender liner retainer.
Use the same procedure for the LH side and RH side.
52521A
27.INSTALL FRONT BUMPER RETAINER CLIP
Install the front bumper retainer clip.
Use the same procedure for the LH side and RH side.