1.INSTALL FRONT BUMPER ASSEMBLY
Install the 2 nuts.
w/o Fog Light:
Engage the 8 claws and install the front bumper assembly.
w/ Fog Light:
Connect the 2 connectors.
Engage the 8 claws and install the front bumper assembly.
Engage the 8 claws and install the front bumper assembly.
Install the 3 clips.
Install the 6 screws.
| *1 | Pin Hold Clip |
| *a | Correct |
| *b | Incorrect |
Install the pin hold clip as shown in the illustration.
Insert the pin hold clip with the slot aligned vertically. Do not rotate the pin hold clip after inserting it. After installation, confirm that the slot is aligned vertically.
Use the same procedure for the LH side and RH side.
Install the clip.
Use the same procedure for the LH side and RH side.
Remove the protective tape.
53101
2.INSTALL RADIATOR GRILLE SUB-ASSEMBLY
Engage the 8 claws and install the radiator grille sub-assembly.
Install the hood center cushion.
Install the 2 clips.
53141F
3.INSTALL RADIATOR COVER
Install the radiator cover with the 8 clips.
4.ADJUST FOG LIGHT AIMING (w/ Fog Light)