Use the same procedure for both the LH and RH side.
The procedure described below is for LH side.
75732B
1.REMOVE FRONT DOOR OUTSIDE MOULDING
| *a | Protective Tape |
Apply protective tape to the vehicle body in the area around the front door outside moulding.
Using an infrared light, heat the vehicle body and front door outside moulding.
| Item | Temperature |
|---|---|
| Vehicle Body and Front Door Outside Moulding | 40 to 60°C (104 to 140°F) |
Do not burn yourself on the hot vehicle body or with the infrared light.
Do not heat the vehicle body and front door outside moulding excessively.
Remove any tape remaining on the vehicle body.
| *a | Wooden Blocks |
| *b | Piano Wire |
| *c | Double-sided Tape |
Pass a piano wire between the vehicle body and the front door outside moulding.
Tie objects that can serve as handles (for example wooden blocks) to both wire ends.
Pull the piano wire and scrape off the double-sided adhesive tape that holds the vehicle body and front door outside moulding.
Be careful not to damage the vehicle body.
Remove the front door outside moulding.
Remove the protective tape.