Use the same procedure for both the LH and RH side.
The procedure described below is for LH side.
75742
1.REMOVE REAR DOOR OUTSIDE MOULDING
| *a | Protective Tape |
| *a | Wooden Blocks |
| *b | Piano Wire |
| *c | Double-sided Adhesive Tape |
Apply protective tape to the vehicle body in the area around the rear door outside moulding.
Using an infrared light, heat the vehicle body and rear door outside moulding.
| Item | Temperature |
|---|---|
| Vehicle Body and Rear Door Outside Moulding | 40 to 60°C (104 to 140°F) |
Do not burn yourself on the hot vehicle body or with the infrared light.
Do not heat the vehicle body and rear door outside moulding excessively.
Remove any tape remaining on the vehicle body.
Pass a piano wire between the vehicle body and the rear door outside moulding.
Tie objects that can serve as handles (for example wooden blocks) to both wire ends.
Pull piano wire and scrape off the double-sided adhesive tape that holds the vehicle body and rear door outside moulding.
Be careful not to damage the vehicle body.
Remove the rear door outside moulding.
Remove the protective tape.