Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR OUTSIDE MOULDING › 2014.03–2018.01
RM30M0E _59 Vehicle Exterior _017128 EXTERIOR PANELS / TRIM _0118071 REAR DOOR OUTSIDE MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR OUTSIDE MOULDING  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the LH and RH side.

·

The procedure described below is for LH side.



PROCEDURE

Hide 75742 1.INSTALL REAR DOOR OUTSIDE MOULDING

a.

Clean the vehicle body surface.

i.

Using an infrared light, heat any adhesive remaining on the vehicle body.

Heating Temperature
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)

CAUTION:

Do not burn yourself on the hot vehicle body or infrared light.


NOTICE:

Do not heat the vehicle body excessively.



ii.

Using a piece of cloth, rub the remaining adhesive off the vehicle body.

NOTICE:

Remove any tape remaining on the vehicle body.



iii.

Using a non-residue solvent, clean the attachment surface.

NOTICE:
·

Make sure there are no foreign substances such as dust, water droplets, oil etc, on the adhesion surface of the vehicle body.

·

Do not use a dirty piece of cloth or contaminated solvent.





b.

Install a new rear door outside moulding as shown in the illustration.

B366743C01
5.969,0.948 5.76,0.625 true 5.74,2.302 6.021,2.24 true 5.99,0.979 6.302,1.177 0.313,0.198 10 false *a 1.406,1.667 1.563,1.865 0.156,0.198 10 false A 1.396,2.208 1.521,2.427 0.125,0.219 10 true A 6.052,2.115 6.365,2.313 0.313,0.198 10 false *b 1.063,0.427 1.375,0.625 0.313,0.198 10 false a 5.354,2.156 5.667,2.354 0.313,0.198 10 false b 5.01,1.01 5.469,1.208 0.458,0.198 10 false A-A
*a Double-sided Adhesive Tape *b Radius Endpoint


Standard Measurement:
Dimension Measurement
a 0.8 to 3.8 mm (0.0315 to 0.149 in.)
b 12.3 mm (0.484 in.)


NOTICE:

Install the rear door outside moulding in an environment where the ambient temperature is over 20°C (68°F). If it is below 20°C (68°F), using an infrared light, heat the vehicle body and the rear door outside moulding to 20 to 30°C (68 to 86°F) and install the rear door outside moulding.


HINT:

Apply sufficient to the surface of the front door outside moulding so that at least 100 kPa (1.0 kgf/cm2, 15 psi) of pressure is applied to the surface of the double-sided tape that contacts the vehicle body.