85292A
1.REMOVE REAR WIPER ARM HEAD CAP
2.REMOVE REAR WIPER ARM AND BLADE ASSEMBLY
81570
3.REMOVE CENTER STOP LIGHT ASSEMBLY
68131
4.REMOVE BACK DOOR GLASS
|
Protective Tape |
Apply protective tape to the installation area on the back door glass on the vehicle body.
| *a | Matchmarks |
Place matchmarks on the back door glass and vehicle body on the locations indicated in the illustration.
Matchmarks are not needed to be placed if the back door glass will not be reused.
Disconnect each connector.
| *a | Piano Wire |
Pass a piano wire between the vehicle body and back door glass from the interior.
Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.
Cut off the adhesive by pulling the piano wire around the back door glass.
When separating the back door glass from the vehicle body, be careful not to damage the paint or interior and exterior ornaments.
Using suction cups, disengage the 2 guides to remove the back door glass.
68294C
5.REMOVE BACK DOOR GLASS ADHESIVE DAM
| *a | Back Side |
Using a scraper, remove the 2 back door glass adhesive dams.
Be careful not to damage the back door glass.
Be sure to replace the back door glass adhesive dam with a new one.
6.REMOVE BACK WINDOW MOULDING PAD
| *a | Back Side |
Using a scraper, remove the 2 back window moulding pads.
Be careful not to damage the back door glass.
Be sure to replace the back window moulding pad with a new one.