Use the same procedure for the LH and RH sides.
The procedure described below is for the LH side.
81110B
1.REMOVE NO. 1 HEADLIGHT BULB (w/o Projector Headlight)
Remove the socket cover.
Release the set spring in the direction indicated by the arrow in the order shown in the illustration.
Remove the No. 1 headlight bulb.
Do not touch the No. 1 headlight bulb glass.
81110B
2.REMOVE NO. 1 HEADLIGHT BULB (w/ Projector Headlight)
Turn the socket cover in the direction indicated by the arrow shown in the illustration to remove it.
Disconnect the connector.
Turn the No. 1 headlight bulb in the direction indicated by the arrow shown in the illustration, and remove it.
Do not touch the No. 1 headlight bulb glass.
81510C
3.REMOVE FRONT TURN SIGNAL LIGHT BULB
Turn the front turn signal light socket with the front turn signal light bulb in the direction indicated by the arrow shown in the illustration, and remove them as a unit.
Remove the front turn signal light bulb from the front turn signal light socket.
81610F
4.REMOVE CLEARANCE LIGHT BULB (w/o Projector Headlight)
Turn the clearance light socket with the clearance light bulb in the direction indicated by the arrow shown in the illustration, and remove them as a unit.
Remove the clearance light bulb from the clearance light socket.
81610F
5.REMOVE CLEARANCE LIGHT BULB (w/ Projector Headlight)
Turn the clearance light socket with the clearance light bulb in the direction indicated by the arrow shown in the illustration, and remove them as a unit.
Remove the clearance light bulb from the clearance light socket.