Use the same procedure for the LH and RH sides.
The procedure described below is for the LH side.
64330
1.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY
64711E
2.REMOVE LUGGAGE COMPARTMENT FLOOR MAT
58410B
3.REMOVE DECK BOARD ASSEMBLY
64772
4.REMOVE SPARE WHEEL COVER PAD
64773B
5.REMOVE NO. 2 SPARE WHEEL COVER PAD
64716D
6.REMOVE REAR DECK TRIM COVER
64740C
7.REMOVE DECK TRIM SIDE PANEL ASSEMBLY
81560
8.REMOVE REAR COMBINATION LIGHT ASSEMBLY
Disconnect the connector.
| *a | Guide |
| *b | Pin |
Remove the 2 screws.
Disengage the 2 guides and 2 pins, remove the rear combination light assembly.
Remove the grommet of the rear combination light socket and wire sub-assembly and pass the connector through the hole to the outside of the vehicle.