Use the same procedure for the LH and RH sides.
The procedure described below is for the LH side.
81550H
1.REMOVE TAIL AND STOP LIGHT BULB
Turn the rear combination light socket and wire sub-assembly with the tail and stop light bulb in the direction indicated by the arrow shown in the illustration, and separate them from the rear turn signal light lens and body as a unit.
Remove the tail and stop light bulb from the rear combination light socket and wire sub-assembly.
81550L
2.REMOVE REAR TURN SIGNAL LIGHT BULB
Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb in the direction indicated by the arrow shown in the illustration, and separate them from the rear turn signal light lens and body as a unit.
Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly.
81550N
3.REMOVE BACK UP LIGHT BULB
Turn the rear combination light socket and wire sub-assembly with the back up light bulb in the direction indicated by the arrow shown in the illustration, and separate them from the rear turn signal light lens and body as a unit.
Remove the back up light bulb from the rear combination light socket and wire sub-assembly.
81565
4.REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY LH
Disengage the 2 clamps to remove the rear combination light socket and wire sub-assembly from the rear turn signal light lens and body.