Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY(for Hatchback) › 2014.03–2017.10
RM30M0E _59 Vehicle Exterior _017126 LIGHTING (EXT) _0120184 REAR COMBINATION LIGHT ASSEMBLY(for Hatchback) A

LIGHTING (EXT)  REAR COMBINATION LIGHT ASSEMBLY(for Hatchback)  REASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH and RH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 81565 1.INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY

a.
E289134

Engage the 2 clamps to install the rear combination light socket and wire sub-assembly to the rear turn signal light lens and body.


Hide 81550N 2.INSTALL BACK UP LIGHT BULB

a.

Install the back up light bulb to the rear combination light socket and wire sub-assembly.


b.
E272707

Turn the rear combination light socket and wire sub-assembly with the back up light bulb in the direction indicated by the arrow shown in the illustration to install them to the rear turn signal light lens and body as a unit.


Hide 81550L 3.INSTALL REAR TURN SIGNAL LIGHT BULB

a.

Install the rear turn signal light bulb to the rear combination light socket and wire sub-assembly.


b.
E276892

Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb in the direction indicated by the arrow shown in the illustration to install them to the rear turn signal light lens and body as a unit.


Hide 81550H 4.INSTALL TAIL AND STOP LIGHT BULB

a.

Install the tail and stop light bulb to the rear combination light socket and wire sub-assembly.


b.
E285377

Turn the rear combination light socket and wire sub-assembly with the tail and stop light bulb in the direction indicated by the arrow shown in the illustration to install them to the rear turn signal light lens and body as a unit.