Home › General › SPECIFICATIONS › 1NZ-FE ENGINE CONTROL › 2014.03–2016.10
RM30M0E _V1 General _017290 SPECIFICATIONS _0096988 1NZ-FE ENGINE CONTROL F

SPECIFICATIONS  1NZ-FE ENGINE CONTROL  SERVICE DATA  


Spark plug standard insulation resistance - 10 MΩ or more
Spark plug electrode gap
(w/ Air Fuel Ratio Sensor (for Sensor 1))
For new spark plug 1.0 to 1.1 mm (0.0394 to 0.0433 in.)
Spark plug electrode gap
(w/ Heated Oxygen Sensor (for Sensor 1))
For new spark plug 0.7 to 0.8 mm (0.0276 to 0.0314 in.)
Spark plug maximum electrode gap
(w/ Air Fuel Ratio Sensor (for Sensor 1))
For used spark plug 1.3 mm (0.0512 in.)
Spark plug maximum electrode gap
(w/ Heated Oxygen Sensor (for Sensor 1))
For used spark plug 1.1 mm (0.0433 in.)
Camshaft timing oil control valve assembly standard resistance 1 - 2 6.9 to 7.9 Ω at 20 °C (68°F)
Throttle body with motor assembly standard resistance 1 (M-) - 2 (M+) 0.3 to 100 Ω at 20 °C (68°F)
Mass air flow meter standard resistance 1 (THA) - 2 (E2) 13.6 to 18.4 kΩ at -20°C (-4°F)
2.21 to 2.69 kΩ at 20°C (68°F)
0.49 to 0.67 kΩ at 60°C (140°F)
Camshaft position sensor standard resistance 1 - 2 1630 to 2740 Ω at cold
2065 to 3225 Ω at hot
Crankshaft position sensor standard resistance 1 - 2 985 to 1600 Ω at cold
1265 to 1890 Ω at hot
Engine coolant temperature sensor standard resistance 1 - 2 2.32 to 2.59 kΩ at 20°C (68°F)
0.310 to 0.326 kΩ at 80°C (176°F)
Knock sensor standard resistance 1 (EKNK) - 2 (KNK1) 120 to 280 kΩ at 20 °C (68°F)
Air Fuel Ratio Sensor (for sensor 1) standard resistance 1 (HT1A) - 2 (+B) 1.6 to 3.2 Ω at 20°C (68°F)
1 (HT1A) - 4 (A1A-) 10 kΩ or higher
Heated oxygen sensor (for sensor 1) standard resistance 1 (HT1A) - 2 (+B) 5.3 to 7.5 Ω at 20°C (68°F)
1 (HT1A) - 4 (E2) 10 kΩ or higher
Heated oxygen sensor (for sensor 2) standard resistance
(w/ Air Fuel Ratio Sensor (for Sensor 1))
1 (HT1B) - 2 (+B) 9 to 14 Ω at 20°C (68°F)
1 (HT1B) - 4 (E2) 10 kΩ or higher
Heated oxygen sensor (for sensor 2) standard resistance
(w/ Heated Oxygen Sensor (for Sensor 1))
1 (HT1B) - 2 (+B) 11 to 16 Ω at 20°C (68°F)
1 (HT1B) - 4 (E2) 10 kΩ or higher
No. 2 ignition relay standard resistance 3 - 5 10 kΩ or higher
(Battery voltage not applied)
Below 1 Ω
(Battery voltage applied between 1 - 2 terminals)