Home › Drivetrain › K411 CVT › CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM › from 2016.04
RM30M0E _52 Drivetrain _052750 K411 CVT _0254682 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM U

K411 CVT  CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM  FAIL-SAFE CHART  


Description


This function minimizes the loss of the Continuously Variable Transaxle (CVT) system functions when a malfunction occurs in a sensor or solenoid valve.


Fail-safe


a.

Fail-safe control list:

Malfunctioning Part Function
Transmission revolution sensor (NT) The ECM calculates the turbine speed based on a signal from the primary pulley speed sensor to perform normal control.
Transmission revolution sensor (NOUT) The ECM calculates the output shaft speed based on a signal from the speed sensor to perform normal control.
Transmission revolution sensor (NIN) The ECM calculates the input shaft speed based on a signal from the turbine speed sensor to perform normal control.
Shift solenoid valve DS1 The ECM stops current to the solenoid valve. The gear ratio is adjusted to a lower ratio compared to the normal ratio.
Shift solenoid valve DS2 The ECM stops current to the solenoid valve. The gear ratio is adjusted to the highest ratio.
Shift solenoid valve SLT The ECM stops current to the solenoid valve and the line pressure becomes equal to the maximum oil pressure.
Shift solenoid valve SLU The ECM stops current to the solenoid valve to completely cancel lock-up.
Shift solenoid valve SLS The ECM stops current to the solenoid valve to maximize the secondary oil pressure in order to set the gear ratio to a predetermined value. Moreover, forward and reverse clutch pressure control using shift solenoid valve SLS is canceled and forward and reverse clutch pressure control is performed only by controlling the oil pressure.
CVT fluid temperature sensor The ECM sets the fluid temperature to a predetermined value to perform normal control.