The skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag ECU assembly) via the CAN communication system.
The airbag ECU assembly has a built-in yaw rate and acceleration sensor and detects the vehicle's condition using 2 circuits (GL1, GL2).
If there is trouble in the bus lines between the yaw rate and acceleration sensor (airbag ECU assembly) and the CAN communication system, DTCs U0124 (Lost Communication with Lateral Acceleration Sensor Module) are set.
These DTCs are also output when calibration has not been completed.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1419 | Acceleration Sensor Internal Circuit | A data malfunction signal is received from the acceleration sensor. | Yaw rate and acceleration sensor (Airbag ECU assembly) |
| C1435 | Yaw Rate Sensor Internal Circuit | A data malfunction signal is received from the yaw rate sensor. | Yaw rate and acceleration sensor (Airbag ECU assembly) |
Refer to DTCs C1232, C1243, C1245, C1279 and C1473.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>C1232
When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION
When replacing the yaw rate and acceleration sensor (airbag ECU assembly), perform zero point calibration and store system information.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION
When U0124 and/or U0126 is output together with C1419 and/or C1435, inspect and repair the trouble areas indicated by U0124 and/or U0126 first.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>U0073
Replace the airbag ECU assembly.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>REMOVAL
If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step.
| Proceed to |
|---|
| NEXT |
NEXT