If the skid control ECU (brake actuator assembly) determines that the vehicle is being driven at a steep bank angle, the skid control ECU (brake actuator assembly) stores DTC C1440 while VSC operation is temporarily disabled.
It is not a malfunction if the system and sensor circuits are normal and if the normal VSC operation resumes, which automatically clears DTC C1440, after the vehicle is returned to a normal position.
DTC C1440 and the yaw rate and acceleration sensor DTC are stored when the skid control ECU (brake actuator assembly) determines that the vehicle is being driven at a steep bank angle and either of the following conditions is met:
The yaw rate and deceleration sensor (airbag sensor assembly) is installed at an angle.
The yaw rate and deceleration sensor (airbag sensor assembly) signal output is stuck.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1440 | Steering Angle Sensor Unusual Bank Angle Detected | Driving at a steep bank angle | Yaw rate and acceleration sensor (Airbag ECU assembly) |
Clear the DTCs.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
Turn the ignition switch off.
Start the engine.
Perform a road test.
Check if the same DTC is recorded.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC C1440 is output | A |
| DTC C1440 is not output | B |
| Yaw rate and acceleration sensor DTC is output | C |
A
B
C
Clear the DTCs.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
If the skid control ECU (brake actuator assembly) determines that the vehicle is being driven at a steep bank angle, the skid control ECU (brake actuator assembly) stores DTC C1440 while VSC operation is temporarily disabled.
It is not a malfunction if the system and sensor circuits are normal and if the normal VSC operation resumes, which automatically clears DTC C1440, after the vehicle is returned to a normal position.
| Proceed to |
|---|
| NEXT |
NEXT