Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2016.04
RM30M0E _54 Brake _017098 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0256246 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1442  Invalid Data Received from Deceleration Sensor  C1443  Invalid Data Received from Yaw Rate Sensor  


DESCRIPTION

The airbag ECU assembly has a built-in yaw rate and acceleration sensor.

The skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag ECU assembly) via the CAN communication system.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1442 Invalid Data Received from Deceleration Sensor Both of the following conditions are met.
1.

With the IG1 terminal voltage between 9.5 and 17.4 V.

2.

An invalid data signal is transmitted continuously from the acceleration sensor for 10 seconds or more.


Yaw rate and acceleration sensor (Airbag ECU assembly)
C1443 Invalid Data Received from Yaw Rate Sensor Both of the following conditions are met.
1.

With the IG1 terminal voltage between 9.5 and 17.4 V.

2.

An invalid data signal is transmitted continuously from the yaw rate and acceleration sensor for 10 seconds or more.


Yaw rate and acceleration sensor (Airbag ECU assembly)

CAUTION / NOTICE / HINT

NOTICE:

When replacing the yaw rate and acceleration sensor (airbag ECU assembly), perform zero point calibration and store system information.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION


PROCEDURE

1.CHECK DTC

Chassis > ABS/VSC/TRC > Clear DTCs
50002 105
b.

Turn the ignition switch off.


c.

Start the engine and idle it for 60 seconds, and then stop the engine.



Chassis > ABS/VSC/TRC > Trouble Codes
50001 105
Result:
Result Proceed to
DTCs C1442 and/or C1443 are output A
DTCs C1442 and C1443 are not output B



A

B