76874B
1.INSTALL REAR SPOILER PROTECTOR LH
Using a piece of cloth, rub off any double-side tape that remains on the rear spoiler cover LH.
Installing the rear spoiler protector LH while any double-sided tape remains on the rear spoiler cover LH may cause adhesion failure. Therefore, completely remove the double-sided tape.
Using a screwdriver or similar tool to remove the old tape can damage the surface and cause adhesion failure.
Using a non-residue solvent, clean the attachment surface.
On the rear spoiler cover LH, coat the attachment surface for the rear spoiler protector LH with primer.
Do not apply the primer too thickly.
| *1 | Rear Spoiler Protector LH |
| *2 | Rear Spoiler Cover LH |
| *a | Marking |
| *b | Double-sided Tape |
Peel off the backing paper of a new rear spoiler protector LH, and install it using sufficient pressure.
Install the rear spoiler protector LH after the primer has dried (approximately 3 minutes).
76873A
2.INSTALL REAR SPOILER PROTECTOR RH
Use the same procedure as for the LH side.
76894
3.INSTALL REAR SPOILER COVER LH
Install the rear spoiler cover LH with the 6 retainers.
Install the clip.
76893A
4.INSTALL REAR SPOILER COVER RH
Use the same procedure as for the LH side.
81920
5.INSTALL REFLEX REFLECTOR ASSEMBLY LH (w/o Rear Fog Light)
81910
6.INSTALL REFLEX REFLECTOR ASSEMBLY RH (w/o Rear Fog Light)
Use the same procedure as for the LH side.
81590B
7.INSTALL REAR FOG LIGHT ASSEMBLY LH (w/ Rear Fog Light)
81580H
8.INSTALL REAR FOG LIGHT ASSEMBLY RH (w/ Rear Fog Light)
Use the same procedure as for the LH side.
9.INSTALL REAR BUMPER ASSEMBLY