Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH › from 2016.04
RM30M0E _51 Engine / Hybrid System _052909 CRUISE CONTROL _0259613 CRUISE CONTROL MAIN SWITCH G

CRUISE CONTROL  CRUISE CONTROL MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 84632 1.INSPECT CRUISE CONTROL MAIN SWITCH

a.

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

C294992C02
5.115,1.135 5.49,0.625 5.49,0.625 5.656,0.625 false 1.75,3.219 2.083,3.135 true 2.708,3.125 3.042,3.208 true 5.708,0.531 6.021,0.688 0.313,0.156 10 false *1 1.427,2.417 1.74,2.573 0.313,0.156 10 false *a 5.656,1.104 5.969,1.26 0.313,0.156 10 false *b 4.615,0.604 4.927,0.76 0.313,0.156 10 false *c 5.073,2.26 5.385,2.417 0.313,0.156 10 false *d 4.083,2.052 4.396,2.208 0.313,0.156 10 false *e 3.094,3.146 3.51,3.313 0.417,0.167 10 false ECC 1.427,3.146 1.844,3.313 0.417,0.167 10 false CCS
*1 Cruise Control Main Switch (ON-OFF Button) - -
*a Component without harness connected
(Cruise Control Main Switch)
*b ON-OFF
*c +/RES *d -/SET
*e CANCEL - -


Standard Resistance:
Tester Connection Switch Condition Specified Condition
1 (ECC) - 3 (CCS) Cruise control main switch (ON-OFF button) released 1 MΩ or higher
Cruise control main switch (ON-OFF button) pushed Below 2.5 Ω
+/RES 235 to 245 Ω
-/SET 617 to 643 Ω
CANCEL 1509 to 1571 Ω


If the result is not as specified, replace the cruise control main switch.