Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT DIMMER SWITCH › 2016.04–2017.10
RM30M0E _59 Vehicle Exterior _017126 LIGHTING (EXT) _0092616 HEADLIGHT DIMMER SWITCH G

LIGHTING (EXT)  HEADLIGHT DIMMER SWITCH  INSPECTION  


PROCEDURE

Hide 84140 1.INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY (w/ Projector Headlight)

a.

Check the resistance.

i.
E347964C01
0.417,1.833 0.865,1.427 true 0.833,1.833 1.25,1.406 true 1.167,1.833 1.417,1.406 true 2,1.833 1.875,1.417 true 2.917,1.833 2.583,1.417 true 2.583,1.833 2.417,1.417 true 1.958,1.083 1.667,0.417 true 2.219,1.083 2.5,0.417 true 2.26,1.833 2.135,1.417 true 0.365,1.865 0.521,2.063 0.156,0.198 10 false H 0.771,1.875 0.927,2.073 0.156,0.198 10 false T 1.042,1.875 1.354,2.073 0.313,0.198 10 false HF 1.958,1.875 2.271,2.073 0.313,0.198 10 false TL 2.865,1.875 3.177,2.073 0.313,0.198 10 false HU 2.542,1.875 2.854,2.073 0.313,0.198 10 false EL 2.573,0.333 3.031,0.531 0.458,0.198 10 false LFG 1.313,0.333 1.771,0.531 0.458,0.198 10 false BFG 2.219,1.875 2.531,2.073 0.313,0.198 10 false TR 0.094,0.083 0.406,0.281 0.313,0.198 10 false *a
*a Component without harness connected
(Headlight Dimmer Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Light Control Switch
Tester Connection Switch Condition Specified Condition
12 (EL) - 18 (T) OFF 10 kΩ or higher
12 (EL) - 18 (T) TAIL Below 1 Ω
12 (EL) - 18 (T) HEAD Below 1 Ω
18 (T) - 20 (H) Below 1 Ω

Dimmer Switch
Tester Connection Switch Condition Specified Condition
12 (EL) - 17 (HF) HIGH FLASH Below 1 Ω
11 (HU) - 12 (EL) Below 1 Ω
11 (HU) - 12 (EL) HIGH Below 1 Ω

Turn Signal Switch
Tester Connection Switch Condition Specified Condition
12 (EL) - 13 (TR) OFF 10 kΩ or higher
12 (EL) - 15 (TL) 10 kΩ or higher
12 (EL) - 13 (TR) RH Below 1 Ω
12 (EL) - 15 (TL) LH Below 1 Ω

Front Fog Light Switch (w/ Fog Light)
Tester Connection Switch Condition Specified Condition
4 (BFG) - 3 (LFG) OFF 10 kΩ or higher
4 (BFG) - 3 (LFG) ON Below 1 Ω


If the result is not as specified, replace the headlight dimmer switch assembly.



Hide 84140 2.INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY (w/o Projector Headlight)

a.

for LHD:

i.

w/o Daytime running light:

1.
E218654C28
0.5,0.75 0.917,0.948 true 1.052,0.896 0.667,0.333 true 2.531,1.25 3,1.583 true 2.167,1.25 2.417,1.75 true 1.958,1.25 2.083,1.75 true 1.677,1.219 1.5,1.75 true 1.479,1.24 1.083,1.75 true 1.271,1.229 0.667,1.75 true 2.333,1.25 2.75,1.75 true 0.896,1.229 0.417,1.583 true 0.115,0.052 0.271,0.229 0.156,0.177 10 false *a 0.167,0.667 0.531,0.906 0.365,0.24 10 false LFG 0.323,0.25 0.75,0.5 0.427,0.25 10 false BFG 3.083,1.5 3.365,1.74 0.281,0.24 10 false TL 2.417,1.802 2.708,2.042 0.292,0.24 10 false E 2.042,1.802 2.385,2.063 0.344,0.26 10 false HL 1.396,1.802 1.708,2 0.313,0.198 10 false HU 0.969,1.792 1.26,2.083 0.292,0.292 10 false T1 0.542,1.781 0.854,2 0.313,0.219 10 false ED 2.698,1.802 3.01,2.083 0.313,0.281 10 false TR 0.135,1.51 0.417,1.75 0.281,0.24 10 false B1
*a Component without harness connected
(Headlight Dimmer Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Light Control Switch
Tester Connection Switch Condition Specified Condition
10 (T1) - 11 (ED) OFF 10 kΩ or higher
10 (T1) - 11 (ED) TAIL Below 1 Ω
10 (T1) - 11 (ED) HEAD Below 1 Ω
13 (B1) - 11 (ED) Below 1 Ω

Dimmer Switch
Tester Connection Switch Condition Specified Condition
8 (HL) - 11 (ED) HIGH FLASH Below 1 Ω
9 (HU) - 11 (ED) Below 1 Ω
9 (HU) - 11 (ED) HIGH Below 1 Ω

Turn Signal Switch
Tester Connection Switch Condition Specified Condition
6 (TR) - 7 (E) OFF 10 kΩ or higher
5 (TL) - 7 (E) 10 kΩ or higher
6 (TR) - 7 (E) RH Below 1 Ω
5 (TL) - 7 (E) LH Below 1 Ω

Front Fog Light Switch (w/ Fog Light)
Tester Connection Switch Condition Specified Condition
3 (BFG) - 4 (LFG) OFF 10 kΩ or higher
3 (BFG) - 4 (LFG) ON Below 1 Ω


If the result is not as specified, replace the headlight dimmer switch assembly.



ii.

w/ Daytime running light:

1.
E347526C03
0.75,0.333 1.24,1.063 true 1.917,0.333 1.521,1.063 true 2.417,1.417 2.833,1.833 true 2.219,1.417 2.583,1.833 true 2.052,1.417 2.167,1.833 true 1.573,1.417 1.333,1.833 true 1.229,1.417 1,1.833 true 1.063,1.406 0.667,1.833 true 0.885,1.292 0.333,1 true 3.083,1.083 2.583,1.281 true 0.094,0.063 0.406,0.219 0.313,0.156 10 false *a 0.417,0.25 1.083,0.5 0.667,0.25 10 false LFG 1.99,0.24 2.448,0.438 0.458,0.198 10 false BFG 0.073,0.917 0.531,1.115 0.458,0.198 10 false HU 0.531,1.875 0.99,2.073 0.458,0.198 10 false EL 0.865,1.875 1.323,2.073 0.458,0.198 10 false TR 1.229,1.875 1.688,2.073 0.458,0.198 10 false TL 2.125,1.875 2.583,2.073 0.458,0.198 10 false HF 2.552,1.875 2.802,2.083 0.25,0.208 10 false T 2.917,1.75 3.188,1.958 0.271,0.208 10 false A 3.167,1 3.365,1.25 0.198,0.25 10 false H
*a Component without harness connected
(Headlight Dimmer Switch Assembly)


Measure the resistance according to the value(s) in the table below.


Standard Resistance:
Light Control Switch
Tester Connection Switch Condition Specified Condition
19 (EL) - 13 (T) OFF 10 kΩ or higher
19 (EL) - 13 (T) TAIL Below 1 Ω
19 (EL) - 13 (T) HEAD Below 1 Ω
13 (T) - 11 (H) Below 1 Ω
19 (EL) - 12 (A) AUTO Below 1 Ω

Dimmer Switch
Tester Connection Switch Condition Specified Condition
19 (EL) - 14 (HF) HIGH FLASH Below 1 Ω
20 (HU) - 19 (EL) HIGH Below 1 Ω

Turn Signal Switch
Tester Connection Switch Condition Specified Condition
19 (EL) - 18 (TR) OFF 10 kΩ or higher
19 (EL) - 16 (TL) 10 kΩ or higher
19 (EL) - 18 (TR) RH Below 1 Ω
19 (EL) - 16 (TL) LH Below 1 Ω

Rear Fog Light Switch (w/ Fog Light)
Tester Connection Switch Condition Specified Condition
7 (BFG) - 8 (LFG) OFF 10 kΩ or higher
7 (BFG) - 8 (LFG) ON Below 1 Ω


If the result is not as specified, replace the headlight dimmer switch assembly.



b.

for RHD:

i.

Check the resistance.

1.
E347964C05
0.417,1.75 0.865,1.417 true 0.75,1.833 1.073,1.417 true 1.083,1.833 1.229,1.417 true 1.75,1.833 1.698,1.417 true 2.167,1.833 2.063,1.417 true 2.5,1.833 2.24,1.417 true 3,1.75 2.583,1.417 true 1.521,1.083 1.917,0.333 true 1.25,1.083 0.917,0.333 true 0.104,0.083 0.417,0.281 0.313,0.198 10 false *a 0.573,0.25 0.99,0.448 0.417,0.198 10 false LFG 2,0.25 2.458,0.448 0.458,0.198 10 false BFG 0.167,1.667 0.479,1.865 0.313,0.198 10 false HU 0.625,1.885 0.938,2.083 0.313,0.198 10 false EL 1.021,1.885 1.333,2.083 0.313,0.198 10 false TL 1.708,1.875 2.021,2.073 0.313,0.198 10 false TR 2.104,1.875 2.417,2.073 0.313,0.198 10 false HF 2.5,1.875 2.656,2.073 0.156,0.198 10 false T 3.083,1.667 3.24,1.865 0.156,0.198 10 false H
*a Component without harness connected
(Headlight Dimmer Switch Assembly)


Measure the resistance according to the value(s) in the table below.


Standard Resistance:
Light Control Switch
Tester Connection Switch Condition Specified Condition
19 (EL) - 13 (T) OFF 10 kΩ or higher
19 (EL) - 13 (T) TAIL Below 1 Ω
19 (EL) - 13 (T) HEAD Below 1 Ω
13 (T) - 11 (H) Below 1 Ω

Dimmer Switch
Tester Connection Switch Condition Specified Condition
19 (EL) - 14 (HF) HIGH FLASH Below 1 Ω
20 (HU) - 19 (EL) Below 1 Ω
20 (HU) - 19 (EL) HIGH Below 1 Ω

Turn Signal Switch
Tester Connection Switch Condition Specified Condition
19 (EL) - 16 (TR) OFF 10 kΩ or higher
19 (EL) - 18 (TL) 10 kΩ or higher
19 (EL) - 16 (TR) RH Below 1 Ω
19 (EL) - 18 (TL) LH Below 1 Ω

Front Fog Light Switch (w/ Fog Light)
Tester Connection Switch Condition Specified Condition
7 (BFG) - 8 (LFG) OFF 10 kΩ or higher
7 (BFG) - 8 (LFG) ON Below 1 Ω


If the result is not as specified, replace the headlight dimmer switch assembly.