Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT LEVELING SWITCH › 2016.04–2017.10
RM30M0E _59 Vehicle Exterior _017126 LIGHTING (EXT) _0259837 HEADLIGHT LEVELING SWITCH G

LIGHTING (EXT)  HEADLIGHT LEVELING SWITCH  INSPECTION  


PROCEDURE

Hide 84152 1.INSPECT HEADLIGHT LEVELING SWITCH

a.
E114455C03
1.563,0.521 2.125,0.635 true 2.583,0.167 2.406,0.625 true 3.083,0.333 2.521,0.667 true 1.417,0.406 1.635,0.646 0.219,0.24 10 false E 2.615,0.01 2.833,0.25 0.219,0.24 10 false T 3.125,0.219 3.344,0.458 0.219,0.24 10 false B 2.427,2.875 2.74,3.073 0.313,0.198 10 false *b 1.49,0.073 1.75,0.333 0.26,0.26 10 false *a
*a Component without harness connected
(Headlight Leveling Switch)
*b Battery


Check the voltage ratio.

i.

Connect the positive (+) battery lead to terminal 1 and the negative (-) battery lead to terminal 4.


ii.

Check the ratio which is obtained by dividing the voltage between terminals 2 and 4 by the voltage between 1 and 4. The voltages must be measured using a voltmeter.

Standard Ratio:
Tester Connection Switch Condition Specified Condition
1 (B) - 4 (E)
2 (T) - 4 (E)
0 0.070 to 0.130
1 0.204 to 0.300
2 0.310 to 0.316
3 0.417 to 0.423
4 0.524 to 0.530
5 0.630 to 0.636


If the result is not as specified, replace the headlight leveling switch.



b.
E190203C12
1.292,1.479 1.042,1.813 true 1.563,1.49 1.49,1.823 true 1.333,1.854 1.74,2.031 0.406,0.177 10 false ILL+ 0.969,1.844 1.135,2.021 0.167,0.177 10 false E 0.26,0.156 0.49,0.344 0.229,0.188 10 false *a
*a Component without harness connected
(Headlight Leveling Switch)


Check that the switch LED illuminates.

i.

Apply battery voltage to the head light leveling switch connector.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 3 (ILL+)
Battery positive (-) → 4 (E)
The illumination comes on


If the illumination does not illuminate, replace the headlight leveling switch.