Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR(for 1NR-FE, 2NR-FE) › from 2016.04
RM30M0E _58 Vehicle Interior _017118 HEATING / AIR CONDITIONING _0259840 COMPRESSOR(for 1NR-FE, 2NR-FE) A

HEATING / AIR CONDITIONING  COMPRESSOR(for 1NR-FE, 2NR-FE)  DISASSEMBLY  


PROCEDURE

Hide 88403 1.REMOVE MAGNET CLUTCH HUB SUB-ASSEMBLY

a.
I111974

Disengage the harness clamp.


b.

Remove the screw and cooler bracket, and disconnect the ground wire.


c.
I112142C03
0.708,1.219 0.646,0.656 false 1.74,1.677 2.219,1.479 true 1.792,2.052 1.635,1.76 false 2.271,1.365 2.583,1.563 0.313,0.198 10 false *a 0.542,0.458 0.854,0.615 0.313,0.156 10 false *b 1.865,1.969 2.323,2.167 0.458,0.198 10 false SST
*a Hold
*b Turn


Fix the cooler compressor with pulley assembly in a vise between aluminum plates.


d.

Using SST, hold the magnet clutch hub.

SST
09985-00270  


e.

Remove the bolt, magnet clutch hub and magnet clutch washer(s).

HINT:

There is no set number of magnet clutch washers(s) since they are used for adjusting.



f.
I112211

Using a snap ring expander, remove the snap ring and magnet clutch rotor.

NOTICE:

Do not damage the seal cover of the bearing when removing the snap ring.



g.
I112212

Using a snap ring expander, remove the snap ring and magnet clutch stator.