Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR(for 1NR-FE, 2NR-FE) › from 2016.04
RM30M0E _58 Vehicle Interior _017118 HEATING / AIR CONDITIONING _0259840 COMPRESSOR(for 1NR-FE, 2NR-FE) A

HEATING / AIR CONDITIONING  COMPRESSOR(for 1NR-FE, 2NR-FE)  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL MAGNETIC CLUTCH ASSEMBLY

a.
I112177C01
2,1.833 1.833,1.125 true 1.417,1.833 1.552,1.167 true 1.938,1.844 2.25,2.042 0.313,0.198 10 false *a 1.344,1.844 1.656,2.042 0.313,0.198 10 false *b
*a Protrusion
*b Notch


Install the magnetic clutch stator while aligning the protrusion on the stator with the notch on the cooler compressor with pulley assembly as shown in the illustration.


b.
I112222

Using a snap ring expander, install a new snap ring with the chamfered side facing up.


c.
I112225

Install the magnet clutch rotor.


d.

Using a snap ring expander, install a new snap ring with the chamfered side facing up.

NOTICE:

Do not damage the seal cover of the bearing when installing the snap ring.



e.

Install the compressor washer(s) and magnet clutch hub.

NOTICE:

Do not change the combination of the compressor washer(s) used before disassembly.



f.
I112144C02
0.51,0.927 0.781,0.771 false 0.781,0.417 1.052,0.26 false 0.688,2.01 1.25,1.813 true 1.104,0.167 1.417,0.323 0.313,0.156 10 false *a 0.479,1.906 0.792,2.063 0.313,0.156 10 false *b 0.219,0.844 0.677,1.042 0.458,0.198 10 false SST
*a Hold
*b Turn


Using SST, hold the magnet clutch hub and install the bolt.

SST
09985-00270  

Torque:
13.2 N*m (135 kgf*cm, 10 ft.*lbf)

NOTICE:

Make sure that there is no foreign matter or oil on the compressor shaft, bolt, and clutch hub.



g.
I111974

Install the cooler bracket and connect the ground wire with the screw.


h.

Engage the wire harness clamp.


Hide 2.INSPECT MAGNET CLUTCH CLEARANCE

a.
I112145

Set a dial indicator to the magnet clutch hub.


b.

Connect the battery positive lead to terminal 1 of the magnet clutch connector and the negative lead to the ground wire. Turn the magnet clutch on and off and measure the clearance.

Standard clearance:

0.25 to 0.50 mm (0.010 to 0.020 in.)


If the measured value is not within the standard clearance, remove the magnet clutch hub and adjust the clearance using compressor washers(s) to obtain the standard clearance.

Compressor washer thickness:

0.1 mm (0.004 in.)

0.3 mm (0.012 in.)

0.5 mm (0.020 in.)


NOTICE:

Adjustment should be performed with 3 or fewer magnet clutch washers.



c.

Remove the cooler compressor with pulley assembly from the vise.