Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC LIGHT CONTROL SENSOR › 2016.04–2017.10
RM30M0E _59 Vehicle Exterior _017126 LIGHTING (EXT) _0259846 AUTOMATIC LIGHT CONTROL SENSOR G

LIGHTING (EXT)  AUTOMATIC LIGHT CONTROL SENSOR  INSPECTION  


PROCEDURE

Hide 1.INSPECT AUTOMATIC LIGHT CONTROL SENSOR

a.
B157083C49
1.521,0.333 1.896,0.552 0.375,0.219 1,1.75 1.406,1.188 true 1.906,1.75 1.656,1.167 true 0.135,0.104 0.344,0.26 0.208,0.156 10 false *a 1.646,0.375 1.854,0.531 0.208,0.156 10 false K1 0.573,1.646 0.979,1.813 0.406,0.167 10 false CLTB 2.01,1.667 2.417,1.833 0.406,0.167 10 false CLTE
*a Front view of wire harness connector
(Automatic Light Control Sensor)


Disconnect the automatic light control sensor connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
K1-1 (CLTB) - K1-2 (CLTE) Ignition switch on (IG) 11 to 14 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
K1-2 (CLTE) - Body ground Always Below 1 Ω



d.
E259758C33
1.531,0.271 1.927,0.49 0.396,0.219 1.833,1.177 2.385,0.885 true 1.458,1.167 0.896,0.896 true 0.188,0.135 0.438,0.313 0.25,0.177 10 false *a 1.667,0.313 1.896,0.552 0.229,0.24 10 false K1 0.542,0.771 0.958,0.948 0.417,0.177 10 false CLTS 2.438,0.792 2.833,0.958 0.396,0.167 10 false CLTE
*a Component with harness connected
(Automatic Light Control Sensor)


Connect the automatic light control sensor connector.


e.

Connect an oscilloscope to the automatic light control sensor connector.


f.
E276298N04
2.844,1.667 3.302,1.865 0.458,0.198 10 false GND

Check the waveform.

OK:
Tester Connection Tool Setting Condition Specified Condition
K1-4 (CLTS) - K1-2 (CLTE) 2 V/DIV., 10 ms./DIV. Ignition switch on (IG), light control switch in AUTO position Correct waveform is as shown


HINT:

The communication waveform changes according to the surrounding brightness.


If the result is not as specified, replace the automatic light control sensor.