Home › Drivetrain › K411 CVT › CONTINUOUSLY VARIABLE TRANSAXLE FLUID › 2016.04–2017.10
RM30M0E _52 Drivetrain _052750 K411 CVT _0259914 CONTINUOUSLY VARIABLE TRANSAXLE FLUID A

K411 CVT  CONTINUOUSLY VARIABLE TRANSAXLE FLUID  REPLACEMENT  


PROCEDURE

Hide 1.REPLACE CONTINUOUSLY VARIABLE TRANSAXLE FLUID

a.

Lift the vehicle. [*1]

NOTICE:

Set the vehicle on a lift so that the vehicle is kept level when it is lifted up (make sure that the tilt angle from the front to rear of the vehicle is within +/- 1°).



b.

Remove the engine under cover LH (w/o Metal type under cover).

Click hereEngine / Hybrid System>1NR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY(for Manual Transaxle)>REMOVAL


c.

Remove the center engine under cover (w/ Metal type under cover).

Click hereEngine / Hybrid System>1NR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY(for Manual Transaxle)>REMOVAL


d.

Remove the No. 1 engine under cover sub-assembly (w/ Metal type under cover).

Click hereEngine / Hybrid System>1NR-FE ENGINE MECHANICAL>ENGINE ASSEMBLY(for Manual Transaxle)>REMOVAL


e.
C219035

Remove the refill plug and gasket from the continuously variable transaxle assembly. [*2]


f.
C219032

Using a 6 mm hexagon socket wrench, remove the overflow plug and gasket from the continuously variable transaxle assembly. [*3]


g.
C288106

Using a 6 mm hexagon socket wrench, remove the No. 1 transmission oil filler tube from the transaxle oil (CVT) pan sub-assembly and drain the fluid. [*4]


h.
C235869

Measure the amount of fluid drained. [*5]

HINT:

Add the same amount of fluid in step [*8].



i.
C288106

Using a 6 mm hexagon socket wrench, install the No. 1 transmission oil filler tube to the transaxle oil (CVT) pan sub-assembly. [*6]

Torque:
0.8 N*m (8 kgf*cm, 7 in.*lbf)


j.
C219032

Temporarily install the gasket and overflow plug to the continuously variable transaxle assembly. [*7]

HINT:

Reuse the old gasket as the overflow plug will be removed again to adjust the fluid level.



k.
C219036

Add fluid to the refill hole using the same amount of fluid drained in step [*5]. [*8]

NOTICE:

Use Toyota Genuine CVT fluid FE.



l.
C219035

Temporarily install the gasket and refill plug to avoid fluid spillage. [*9]

HINT:

Reuse the old gasket as the refill plug will be removed again to adjust the fluid level.



m.

Lower the vehicle. [*10]


n.

Start the engine. [*11]


o.

Slowly move the shift lever from P to D, and then back to P (keep the shift lever in each position for approximately 3 seconds). [*12]

HINT:

Slowly move the shift lever to circulate the fluid through each part of the continuously variable transaxle assembly.



p.

Allow the engine assembly to idle for 30 seconds to warm it up. [*13]


q.

Turn the ignition switch off. [*14]


r.

Repeat steps [*1] to [*14].


s.

Repeat steps [*1] to [*10].