Home › Drivetrain › K411 CVT › OIL PAN › from 2016.04
RM30M0E _52 Drivetrain _052750 K411 CVT _0259918 OIL PAN A

K411 CVT  OIL PAN  REMOVAL  


PROCEDURE

Hide 51442C 1.REMOVE ENGINE UNDER COVER LH (w/o Metal Type Under Cover)

Hide 51451A 2.REMOVE CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)

Hide 51405A 3.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)

Hide 4.DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID

a.
C219035

Remove the refill plug and gasket from the continuously variable transaxle assembly.


b.
C219032

Using a 6 mm hexagon socket wrench, remove the overflow plug and gasket from the continuously variable transaxle assembly.


c.
C288106

Using a 6 mm hexagon socket wrench, remove the No. 1 transmission oil filler tube from the transaxle oil (CVT) pan sub-assembly and drain the fluid.


d.

Using a 6 mm hexagon socket wrench, install the No. 1 transmission oil filler tube to the transaxle oil (CVT) pan sub-assembly.

Torque:
0.8 N*m (8 kgf*cm, 7 in.*lbf)


e.

Temporarily install the gasket and overflow plug to the continuously variable transaxle assembly.

HINT:

Reuse the old gasket as the overflow plug will be removed again to adjust the fluid level.



f.

Temporarily install the gasket and refill plug to the continuously variable transaxle assembly.

HINT:

Reuse the old gasket as the refill plug will be removed again to adjust the fluid level.



Hide 35106L 5.REMOVE TRANSAXLE OIL (CVT) PAN SUB-ASSEMBLY

a.
C288107

Remove the 15 bolts, transaxle oil (CVT) pan sub-assembly and transaxle oil (CVT) pan gasket from the continuously variable transaxle assembly.

NOTICE:

Some fluid will remain in the transaxle oil (CVT) pan sub-assembly. Remove all the bolts, and carefully remove the transaxle oil (CVT) pan sub-assembly.



b.

Using a 6 mm hexagon socket wrench, remove the overflow plug and gasket from the transaxle oil (CVT) pan sub-assembly.


c.

Using a 6 mm hexagon socket wrench, remove the No. 1 transmission oil filler tube from the transaxle oil (CVT) pan sub-assembly.


Hide 35394D 6.REMOVE OIL CLEANER (CVT) MAGNET

a.
C266001C03
1.635,1.427 2.938,0.802 2.938,0.802 1.99,1.49 true 2.958,0.688 3.271,0.844 0.313,0.156 10 false *1
*1 Oil Cleaner (CVT) Magnet


Remove the 2 oil cleaner magnets from the transaxle oil (CVT) pan sub-assembly.


b.

Clean off any metal particles adhered to the oil cleaner (CVT) magnets.


c.

Clean the transaxle oil (CVT) pan sub-assembly and remove any metal particles, sludge, etc.