Home › Drivetrain › K411 CVT › OIL PRESSURE SENSOR › from 2016.04
RM30M0E _52 Drivetrain _052750 K411 CVT _0259921 OIL PRESSURE SENSOR A

K411 CVT  OIL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89637K 1.INSTALL OIL PRESSURE SENSOR

a.

Apply a light coat of Toyota Genuine CVT fluid FE to the O-ring of the oil pressure sensor.

NOTICE:

If reusing the oil pressure sensor, check that the O-ring is not damaged.



b.
C234037N03
1.885,1.594 1.938,1.823 false 1.813,1.833 2.156,2.031 0.344,0.198 10 false SST

Using SST, install the oil pressure sensor to the continuously variable transaxle assembly.

SST
09268-46012  

Torque:
29.4 N*m (300 kgf*cm, 22 ft.*lbf)

NOTICE:

Make sure that the O-ring is not damaged or does not jump out of position during installation.



c.

Connect the oil pressure sensor connector.


Hide 2.INSPECT FOR CONTINUOUSLY VARIABLE TRANSAXLE FLUID LEAK

Hide 51442C 3.INSTALL ENGINE UNDER COVER LH (w/o Metal Type Under Cover)

Hide 51405A 4.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)

Hide 51451A 5.INSTALL CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)

Hide 6.RESET MEMORY (CVT oil pressure calibration)