Home › Drivetrain › K411 CVT › SHIFT LEVER › 2016.04–2017.10
RM30M0E _52 Drivetrain _052750 K411 CVT _0259924 SHIFT LEVER A

K411 CVT  SHIFT LEVER  REMOVAL  


PROCEDURE

Hide 33820B 2.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Apply the parking brake and move the shift lever to N.


b.
C286312

Disconnect the end of the transmission control cable assembly from the transmission floor shift assembly.


c.
C286314C02
0.615,1.427 0.688,1.208 false 0.552,1.438 0.865,1.594 0.313,0.156 10 false *1
*1 Nut
V100135

Rotate approximately 180°
V100136

Pull out


Rotate the nut of the transmission control cable assembly approximately 180° in the direction shown in the illustration, and while holding the nut, separate the transmission control cable assembly from the transmission floor shift assembly.

NOTICE:

Rotating the nut too much will damage the internal spring, and the transmission control cable assembly will not be reusable. Do not turn the nut too far.



Hide 33550 3.REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY (for LHD)

a.
C354309

Disconnect the 2 connectors from the transmission floor shift assembly.


b.

Disengage the 3 clamps to separate the wire harness from the transmission floor shift assembly.


c.
C354303

Remove the 4 bolts and transmission floor shift assembly from the body.


Hide 33550 4.REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY (for RHD)

a.
C354293

Disconnect the 2 connectors from the transmission floor shift assembly.


b.

Disengage the 3 clamps to separate the wire harness from the transmission floor shift assembly.


c.
C282029

Remove the 4 bolts and transmission floor shift assembly from the body.