23250
1.INSPECT FUEL INJECTOR ASSEMBLY
| *a | Component without harness connected
(Fuel Injector Assembly) |
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | 20°C (68°F) | 11.6 to 12.4 Ω |
If the result is not as specified, replace the fuel injector assembly.
Inspect the fuel injector injection volume.
Keep the fuel injector assembly away from sparks during the test.
| *1 | Fuel Pipe (Vehicle Side) |
| *a | SST (Hose) |
| *b | SST (Hose Band) |
| *c | SST (Fuel Tube Connector) |
Connect SST (fuel tube connector) to SST (hose) with SST (hose band), and then connect them to the fuel pipe (vehicle side).
| *1 | O-ring |
| *a | SST (Hose) |
| *b | SST (Hose Band) |
| *c | SST (Adapter) |
| *d | SST (Clamp) |
| *e | Vinyl Tube |
Install a new O-ring to the fuel injector assembly.
Connect SST (adapter and hose) to the fuel injector assembly, and hold the fuel injector assembly and union with SST (clamp).
Install a vinyl tube to the fuel injector assembly.
Install a suitable vinyl tube to the fuel injector assembly to prevent fuel from spraying.
| *a | SST (Tie Band) |
| *b | SST (Adapter) |
| *c | SST (Clamp) |
Tie SST (clamp) and SST (adapter) together with SST (tie band) as shown in the illustration.
Put the fuel injector assembly to a graduated cylinder.
Operate the fuel pump.
Click hereEngine / Hybrid System>1NR-FE ENGINE CONTROL>SFI SYSTEM>DATA LIST / ACTIVE TEST
| *a | SST (Wire) |
| *b | Connect |
Connect SST (wire) to the fuel injector assembly and battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each fuel injector assembly 2 or 3 times.
Always switch the voltage on and off at the battery side, not the fuel injector assembly side.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| Positive terminal - Ground terminal | Per 15 seconds | 47 to 57 cc (2.9 to 3.5 cu in.) |
10 cc (0.6 cu in.) or less
If the result is not as specified, replace the fuel injector assembly.
Check for fuel drop.
In the condition above, disconnect the tester probes of SST (wire) from the battery and check for fuel drop from the fuel injector assembly.
1 drop or less every 25 minutes
If the result is not as specified, replace the fuel injector assembly.