Home › Engine / Hybrid System › 1NR-FE COOLING › COOLING SYSTEM › from 2016.04
RM30M0E _51 Engine / Hybrid System _053564 1NR-FE COOLING _0259955 COOLING SYSTEM G

1NR-FE COOLING  COOLING SYSTEM  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

CAUTION:

Be sure that the ignition switch is off if you work near the electric cooling fans or radiator grille. With the ignition switch ON, the electric cooling fans may automatically start to run if the engine coolant temperature is high and/or the air conditioning is on (w/ air conditioning system).


PROCEDURE

Hide 1.INSPECT FOR COOLANT LEAK

a.

Remove the radiator cap sub-assembly from the radiator assembly.


b.

Fill the radiator reserve tank assembly with engine coolant, and then install a radiator cap tester.


c.

Warm up the engine.


d.
A312089C01
0.844,0.802 0.573,0.375 false 0.417,0.25 0.729,0.406 0.313,0.156 10 false *a
*a Radiator Cap Tester


Pump the radiator cap tester to 137 kPa (1.4 kgf/cm2, 20 psi), and then check that the pressure does not drop.

·

If the engine coolant level is low, perform engine coolant leak inspection, and fill new engine coolant.

·

If there are no signs of external engine coolant leaks, check the heater core, cylinder block sub-assembly and cylinder head sub-assembly.



e.

Remove the radiator cap tester.


f.

Install the radiator cap sub-assembly to the radiator assembly.


Hide 2.INSPECT RESERVOIR TANK COOLANT LEVEL

a.
A381282C01
0.5,0.917 1.01,1.021 true 0.5,1.563 1.01,1.667 true 0.323,0.802 0.635,1 0.313,0.198 10 false *a 0.323,1.448 0.635,1.646 0.313,0.198 10 false *b
*a Full Line
*b Low Line


Check that the engine coolant level in the reserve tank is between the low line and full line when the engine is cold.

NOTICE:

Do not substitute plain water for engine coolant.


If the engine coolant level is low, perform engine coolant leak inspection, and fill new engine coolant.


Hide 3.INSPECT ENGINE COOLANT QUALITY

CAUTION:

Do not remove the radiator cap sub-assembly while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


a.

Remove the radiator cap sub-assembly from the radiator assembly.


b.

Check for excessive deposits of rust or scale around the radiator cap sub-assembly and radiator filler hole. The engine coolant should be free of oil.

If excessively dirty, replace the engine coolant.


c.

Install the radiator cap sub-assembly to the radiator assembly.