Be sure that the ignition switch is off if you work near the electric cooling fans or radiator grille. With the ignition switch ON, the electric cooling fans may automatically start to run if the engine coolant temperature is high and/or the air conditioning is on (w/ air conditioning system).
1.INSPECT COOLING FAN SYSTEM OPERATION AT LOW TEMPERATURES
Check and ensure the following conditions:
The ignition switch is off.
The engine coolant temperature is less than 83°C (181°F).
The A/C switch is off (w/ air conditioning system).
Turn the ignition switch to ON and wait for approximately 10 seconds. Check that the fan is not operating.
Check that the fan operates when the water temperature sensor connector is disconnected.
2.INSPECT COOLING FAN SYSTEM OPERATION AT HIGH TEMPERATURES
Check and ensure the following conditions:
Warm up the engine.
The engine coolant temperature is less than 94°C (201°F).
The A/C switch is off (w/ air conditioning system).
Start the engine. Check that the fan is not operating.
Check that the fan starts operating when the engine coolant temperature reaches approximately 97°C (207°F).
This system can also be checked using the GTS.
Enter the following menus: Powertrain / Engine and ECT / Data List / Coolant Temp.
| Tester Display |
|---|
| Coolant Temp |