Home › Engine / Hybrid System › 1NR-FE COOLING › THERMOSTAT › from 2016.04
RM30M0E _51 Engine / Hybrid System _053564 1NR-FE COOLING _0259959 THERMOSTAT G

1NR-FE COOLING  THERMOSTAT  INSPECTION  


PROCEDURE

Hide 16321 1.INSPECT WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

a.

Check the valve opening temperature of the water inlet with thermostat sub-assembly.

Standard valve opening temperature:

80 to 84°C (176 to 183°F)


If the valve opening temperature is not as specified, replace the water inlet with thermostat sub-assembly.


b.
A256585C02
1.24,0.01 1.552,0.167 0.313,0.156 10 *a
*a 8.5 mm or more


Check the valve lift.

Standard valve lift:

8.5 mm (0.335 in.) or more at 95°C (203°F)


If the result is not as specified, replace the water inlet with thermostat sub-assembly.


c.

Check that the valve is fully closed when the water inlet with thermostat sub-assembly is at low temperatures (below 77°C (171°F)).

If it is not fully closed, replace the water inlet with thermostat sub-assembly.