Home › Engine / Hybrid System › 1NR-FE COOLING › RELAY › from 2016.04
RM30M0E _51 Engine / Hybrid System _053564 1NR-FE COOLING _0259963 RELAY G

1NR-FE COOLING  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85927 1.INSPECT FAN NO. 1 RELAY

E209082

a.

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
Battery voltage applied to terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the FAN No. 1 relay.




Hide 85927A 2.INSPECT FAN NO. 2 RELAY

E263308E01
2.688,0.542 3.042,0.25 true 2.698,1.031 3.052,0.844 true 2.521,1.854 2.521,1.583 true 1.896,1.844 2.208,1.573 true 3.135,1.844 2.833,1.573 true 2.49,1.865 2.646,2.063 0.156,0.198 10 false 4 1.865,1.865 2.021,2.063 0.156,0.198 10 false 2 3.115,1.865 3.271,2.063 0.156,0.198 10 false 1 3.115,0.76 3.271,0.958 0.156,0.198 10 false 5 3.115,0.156 3.271,0.354 0.156,0.198 10 false 3

a.

Check the resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 4 Battery voltage not applied to terminals 1 and 2 Below 1 Ω
3 - 5 10 kΩ or higher
3 - 4 Battery voltage applied to terminals 1 and 2 10 kΩ or higher
3 - 5 Below 1 Ω


If the result is not as specified, replace the FAN No. 2 relay.