Home › Engine / Hybrid System › 2NR-FE COOLING › COOLING FAN SYSTEM › from 2016.04
RM30M0E _51 Engine / Hybrid System _053565 2NR-FE COOLING _0259965 COOLING FAN SYSTEM G

2NR-FE COOLING  COOLING FAN SYSTEM  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

CAUTION:

Be sure that the ignition switch is off if you work near the electric cooling fans or radiator grille. With the ignition switch ON, the electric cooling fans may automatically start to run if the engine coolant temperature is high and/or the air conditioning is on (w/ air conditioning system).


PROCEDURE

Hide 1.INSPECT COOLING FAN SYSTEM OPERATION AT LOW TEMPERATURES

a.

Check and ensure the following conditions:

i.

The ignition switch is off.


ii.

The engine coolant temperature is less than 83°C (181°F).


iii.

The A/C switch is off (w/ air conditioning system).



b.

Turn the ignition switch to ON and wait for approximately 10 seconds. Check that the fan is not operating.


c.

Check that the fan operates when the water temperature sensor connector is disconnected.


Hide 2.INSPECT COOLING FAN SYSTEM OPERATION AT HIGH TEMPERATURES

a.

Check and ensure the following conditions:

i.

Warm up the engine.


ii.

The engine coolant temperature is less than 94°C (201°F).


iii.

The A/C switch is off (w/ air conditioning system).



b.

Start the engine. Check that the fan is not operating.


c.

Check that the fan starts operating when the engine coolant temperature reaches approximately 97°C (207°F).

HINT:

This system can also be checked using the GTS.

Enter the following menus: Powertrain / Engine and ECT / Data List / Coolant Temp.


Powertrain > Engine and ECT > Data List
Tester Display
Coolant Temp
50003 234 8