1.INSPECT CHARCOAL CANISTER
Visually check the charcoal canister.
Visually check the charcoal canister for cracks or damage.
If cracks or damage are found, replace the charcoal canister.
Inspect the ventilation of the canister.
| *a | Port A |
| *b | Port B |
| *c | Air |
Apply compressed air to port B and check that the air flows out from port A.
The air flows out from the port A.
Inspect the check valve.
| *a | Port A |
| *b | Port B |
| *c | Air |
Close the port A, and apply the compressed air from the port B.
Air does not flow at first. By gradually increasing the pressure, air flows when the pressure in the port reaches the specified level.
| *a | Port A |
| *b | Port B |
| *c | Vacuum Pump |
Close the port A, and apply a vacuum from the port B, using a vacuum pump.
The vacuum is maintained at first. By gradually increasing the vacuum, air flows and the vacuum decreases after the vacuum reaches the specified level.