33493C
1.INSTALL TRANSMISSION OIL COOLER
Apply Toyota Genuine CVT fluid FE to 2 new O-rings, and install them to the transmission oil cooler.
Install the transmission oil cooler to the continuously variable transaxle assembly with the 3 bolts.
Be careful not to damage the O-rings.
16260
2.CONNECT WATER BY-PASS HOSE ASSEMBLY
| *a | View A |
| *b | Front of Vehicle |
| *c | Left of Vehicle |
| *d | Paint Mark |
Connect the 2 water by-pass hoses to the transmission oil cooler and slide the 2 hose clips to secure them as shown in the illustration.
Fully insert the 2 water by-pass hoses until the 2nd rib on each transmission oil cooler pipe.
Perform the installation with the hose clips at the correct directions.
3.ADD ENGINE COOLANT
4.ADD CONTINUOUSLY VARIABLE TRANSAXLE FLUID
5.INSPECT FOR COOLANT LEAK
6.INSPECT FOR CONTINUOUSLY VARIABLE TRANSAXLE FLUID LEAK
51442C
7.INSTALL ENGINE UNDER COVER LH (w/o Metal Type Under Cover)
51405A
8.INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)
51451A
9.INSTALL CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)