Home › Drivetrain › K312 CVT › SHIFT LEVER › 2016.04–2017.10
RM30M0E _52 Drivetrain _052969 K312 CVT _0259997 SHIFT LEVER A

K312 CVT  SHIFT LEVER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY

a.
C354303N01
0.74,2.427 0.896,2.625 0.156,0.198 10 true 1 2.479,1.094 2.635,1.292 0.156,0.198 10 true 2 0.74,1.073 0.896,1.271 0.156,0.198 10 true 3 2.458,2.396 2.615,2.594 0.156,0.198 10 true 4

Temporarily install the transmission floor shift assembly to the body with the 4 bolts.


b.

Fully tighten the 4 bolts in the order shown in the illustration.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)


c.

Engage the 3 clamps to install the wire harness to the transmission floor shift assembly.


d.

Connect the 2 connectors to the transmission floor shift assembly.


Hide 33820B 2.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

a.
C288539C01
2.24,0.906 2.552,0.708 false 1,1.875 1.313,1.677 false 0.854,1.781 1.167,1.938 0.313,0.156 10 false *1 2.594,0.604 2.906,0.76 0.313,0.156 10 false *2
*1 Nut
*2 Lock
V100135

Rotate approximately 180°
V100136

Push in


Rotate the nut of the transmission control cable assembly approximately 180° in the direction shown in the illustration, and while holding the nut, push in the lock.

NOTICE:

Rotating the nut too much will damage the internal spring, and the transmission control cable assembly will not be reusable. Do not turn the nut too far.



b.
C293638C01
0.781,2.406 0.594,2.229 false 2.604,2.406 2.417,2.229 false 2.26,2.125 2.573,2.281 0.313,0.156 10 false *1 0.438,2.115 0.75,2.271 0.313,0.156 10 false *a 1.219,2.375 1.375,2.573 0.156,0.198 10 false A 0.281,2.375 0.438,2.573 0.156,0.198 10 false A
*1 Lock
*a Protrusion
V100135

Push in


Install the transmission control cable assembly to the transmission floor shift assembly.

NOTICE:
·

Install the transmission control cable assembly with the protrusion facing upwards.

·

After installation, make sure that the lock is projecting from A as shown in the illustration.

·

Make sure that the transmission control cable assembly is securely locked.




c.
C293639

Confirm that the shift lever is in N, and then connect the end of the transmission control cable assembly to the transmission floor shift assembly.

NOTICE:
·

Securely install the end of the transmission control cable assembly to the transmission floor shift assembly.

·

Install the end of the transmission control cable assembly so that its adjustment lock section is on the driver side.




Hide 3.ADJUST SHIFT LEVER POSITION

Hide 4.INSPECT SHIFT LEVER POSITION