Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR › from 2016.04
RM30M0E _54 Brake _017098 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0090185 BRAKE ACTUATOR G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE ACTUATOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.CONNECT GTS

a.

Warm up the engine.


b.

Turn the ignition switch off.


c.

Connect the GTS to the DLC3.


d.

Turn the ignition switch to ON.


e.

Turn the GTS on.

HINT:

Refer to the GTS Operator's Manual for further details.



Hide 2.INSPECT ACTUATOR MOTOR OPERATION

NOTICE:

Do not keep the motor relay on continuously for more than 5 seconds. If it needs to be operated repeatedly, set an interval of more than 20 seconds between operations.


a.

Enter the following menus: Chassis / ABS/VSC/TRC / Active Test / Motor Relay.

Chassis > ABS/VSC/TRC > Active Test
Tester Display
Motor Relay
50004 105 2

b.

Turn the motor relay on and check for the actuator motor operation sound.


c.

Turn the motor relay off.


d.

Fully depress the brake pedal and hold it for approximately 15 seconds. Check that the pedal's initial depth is maintained for the entire 15 seconds.


e.

Turn the motor relay on and check that the pedal does not pulsate.


f.

Turn the motor relay off and release the brake pedal.


Hide 3.INSPECT RIGHT FRONT WHEEL OPERATION

NOTICE:

Do not turn on a solenoid in a manner different from that shown in the following steps.


a.

Enter the following menus: Chassis / ABS/VSC/TRC / Active Test / ABS Solenoid (SFRH) and ABS Solenoid (SFRR).

Chassis > ABS/VSC/TRC > Active Test
Tester Display
ABS Solenoid (SFRR)
50004 105 16
Chassis > ABS/VSC/TRC > Active Test
Tester Display
ABS Solenoid (SFRH)
50004 105 15

b.

Depress the brake pedal and hold it.


c.

Turn the SFRH and SFRR solenoids on simultaneously and check that the pedal cannot be depressed.

NOTICE:

Each solenoid operates for 2 seconds and turns off automatically. If it needs to be operated repeatedly, set an interval of more than 20 seconds between operations.



d.

Turn the SFRH and SFRR solenoids off simultaneously and check that the pedal can be depressed.


e.

Turn the motor relay on and check that the pedal returns.

NOTICE:

Do not keep the motor relay on continuously for more than 5 seconds. If it needs to be operated repeatedly, set an interval of more than 20 seconds between operations.



f.

Turn the motor relay off and release the brake pedal.


Hide 4.INSPECT OTHER WHEEL OPERATION

a.

Using the same procedure, check the solenoids of the other wheels.

HINT:
·

Left front wheel: SFLH, SFLR

·

Right rear wheel: SRRH, SRRR

·

Left rear wheel: SRLH, SRLR