15330A
1.INSTALL CAM TIMING OIL CONTROL VALVE O-RING
This procedure is performed when the cam timing oil control valve O-ring must be replaced with a new one.
Install a new cam timing oil control valve O-ring to the camshaft timing oil control valve assembly.
Do not damage the cam timing oil control valve O-ring.
11101J
2.INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Intake Side)
Apply a light coat of engine oil to the cam timing oil control valve O-ring and install it to the camshaft timing oil control valve assembly.
Do not twist the cam timing oil control valve O-ring.
Install the camshaft timing oil control valve assembly to the cylinder head cover sub-assembly with the bolt.
Do not allow foreign matter to contact the oil seal face of the camshaft timing oil control valve assembly (connecting surface with the cylinder head cover sub-assembly).
Make sure that the camshaft timing oil control valve assembly is not cracked or moved out of place when installing the camshaft timing oil control valve assembly.
If the camshaft timing oil control valve assembly has been struck or dropped, replace it.
Connect the camshaft timing oil control valve assembly connector.
11101J
3.INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (for Exhaust Side)
Apply a light coat of engine oil to the cam timing oil control valve O-ring and install it to the camshaft timing oil control valve assembly.
Do not twist the cam timing oil control valve O-ring.
Install the camshaft timing oil control valve assembly to the cylinder head cover sub-assembly with the bolt.
Do not allow foreign matter to contact the oil seal face of the camshaft timing oil control valve assembly (connecting surface with the cylinder head cover sub-assembly).
Make sure that the camshaft timing oil control valve assembly is not cracked or moved out of place when installing the camshaft timing oil control valve assembly.
If the camshaft timing oil control valve assembly has been struck or dropped, replace it.
Connect the camshaft timing oil control valve assembly connector.
4.INSPECT FOR ENGINE OIL LEAK
12611
5.INSTALL NO. 1 ENGINE COVER
Engage the 2 front grommets, then the rear grommets to install the No. 1 engine cover to the cylinder head cover sub-assembly.
Be sure to engage the grommets securely.