Home › Engine / Hybrid System › 1NR-FE ENGINE CONTROL › THROTTLE BODY › from 2016.04
RM30M0E _51 Engine / Hybrid System _053310 1NR-FE ENGINE CONTROL _0260016 THROTTLE BODY G

1NR-FE ENGINE CONTROL  THROTTLE BODY  INSPECTION  


PROCEDURE

Hide 22030 1.INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY

a.

Check the resistance.

i.
A171212C01
2,1.781 2.188,1.344 true 2.74,1.781 2.51,1.344 true 0.115,0.115 0.427,0.313 0.313,0.198 10 false *a 1.896,1.823 2.208,2.021 0.313,0.198 10 false M+ 2.667,1.823 2.979,2.021 0.313,0.198 10 false M-
*a Component without harness connected
(Throttle Body with Motor Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (M-) - 2 (M+) 20°C (68°F) 0.3 to 100 Ω


If the result is not as specified, replace the throttle body with motor assembly.