1.DRAIN ENGINE COOLANT
12611
2.REMOVE NO. 1 ENGINE COVER
17341T
3.DISCONNECT NO. 1 AIR HOSE (for CVT)
Slide the hose clip and disconnect the No. 1 air hose from the air cleaner hose assembly.
12262
4.DISCONNECT NO. 2 VENTILATION HOSE
Slide the hose clip and disconnect the No. 2 ventilation hose from the air cleaner hose assembly.
5.REMOVE AIR CLEANER HOSE ASSEMBLY
Disengage the clamp to disconnect the purge VSV from the air cleaner hose assembly.
Loosen the hose clamp and disconnect the air cleaner hose assembly from the air cleaner cap sub-assembly.
Lock the hose clip and remove the air cleaner hose assembly from the throttle body with motor assembly.
6.REMOVE WIRE HARNESS CLAMP BRACKET
Disengage the clamp to disconnect the wire harness from the wire harness clamp bracket.
Disconnect the throttle body with motor assembly connector.
Disengage the clamp to disconnect the hose clamp from the wire harness clamp bracket.
Remove the 2 bolts and wire harness clamp bracket from the intake manifold and wire harness clamp bracket.
12261
7.DISCONNECT VENTILATION HOSE
Disengage the 2 clamps to disconnect the ventilation hose from the 2 hose clamps.
Slide the hose clip and disconnect the ventilation hose from the PCV valve (ventilation valve sub-assembly).
16267
8.DISCONNECT NO. 3 WATER BY-PASS HOSE
Slide the hose clip and disconnect the No. 3 water by-pass hose from the throttle body with motor assembly.
16264
9.DISCONNECT NO. 2 WATER BY-PASS HOSE
Slide the hose clip and disconnect the No. 2 water by-pass hose from the throttle body with motor assembly.
22030
10.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
| *1 | Wire Harness Clamp Bracket |
Remove the 3 bolts, wire harness clamp bracket and throttle body with motor assembly from the intake manifold.
If a component has been dropped or subjected to a strong impact, replace the throttle body with motor assembly.
22271
11.REMOVE THROTTLE BODY GASKET
Remove the throttle body gasket from the intake manifold.