22030
1.CHECK THROTTLE BODY WITH MOTOR ASSEMBLY
Check the idle speed.
Start the engine and check that the MIL is not illuminated. After the engine is warmed up, check that the idle speed is within the specified range with the A/C switch off (w/ air conditioning system).
| Transaxle | Idle Speed |
|---|---|
| Continuously Variable Transaxle | 600 to 700 rpm |
| Manual Transaxle | 550 to 650 rpm |
Be sure to perform this step with all accessories off.
Make sure that the shift lever is in P or N (neutral).
Perform a road test and confirm that there are no abnormalities.
Check the throttle position sensor.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Throttle Position No. 1 and Throttle Position No. 2.
| Tester Display |
|---|
| Throttle Position No.1 |
| Throttle Position No.2 |
Depress the accelerator pedal. When the throttle valve is fully open, check that the value of Throttle Sensor Position is as specified.
| Tester Display | Specified Condition |
|---|---|
| Throttle Sensor Position | 60% or higher |
When checking the throttle valve opening percentage, the shift lever should be in N (neutral).
Fully depress the accelerator pedal.
If the percentage is less than 60%, replace the throttle body with motor assembly.