Home › Engine / Hybrid System › 1NR-FE ENGINE CONTROL › MASS AIR FLOW METER › from 2016.04
RM30M0E _51 Engine / Hybrid System _053310 1NR-FE ENGINE CONTROL _0260019 MASS AIR FLOW METER A

1NR-FE ENGINE CONTROL  MASS AIR FLOW METER  INSTALLATION  


PROCEDURE

Hide 22204 1.INSTALL MASS AIR FLOW METER

a.

Install the mass air flow meter to the air cleaner cap sub-assembly with the 2 screws.

NOTICE:
·

If reusing the mass air flow meter, be sure to inspect the O-ring.

·

If a component has been dropped or subjected to a strong impact, replace the mass air flow meter.

·

Make sure that the O-ring is not damaged or does not jump out of position during installation.



HINT:

Perform "Inspection After Repairs" after replacing the mass air flow meter.

Click hereEngine / Hybrid System>1NR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION



b.

Connect the mass air flow meter connector.


Hide 2.PERFORM INITIALIZATION

a.

Perform "Inspection After Repair" after replacing the mass air flow meter.

Click hereEngine / Hybrid System>1NR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION