12611
1.REMOVE NO. 1 ENGINE COVER
11101W
2.REMOVE CAMSHAFT POSITION SENSOR (for Exhaust Side)
Disconnect the camshaft position sensor connector.
Remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.
If a component has been dropped or subjected to a strong impact, replace the camshaft position sensor.
11101W
3.REMOVE CAMSHAFT POSITION SENSOR (for Intake Side)
Disconnect the camshaft position sensor connector.
Remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.
If a component has been dropped or subjected to a strong impact, replace the camshaft position sensor.