Home › Engine / Hybrid System › 1NR-FE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR › 2016.04–2017.10
RM30M0E _51 Engine / Hybrid System _053310 1NR-FE ENGINE CONTROL _0260021 CRANKSHAFT POSITION SENSOR A

1NR-FE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 51441C 1.REMOVE ENGINE UNDER COVER RH (w/o Metal Type Under Cover)

Hide 51451A 2.REMOVE CENTER ENGINE UNDER COVER (w/ Metal Type Under Cover)

Hide 51405A 3.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Metal Type Under Cover)

Hide 11301K 4.REMOVE CRANKSHAFT POSITION SENSOR

a.
A277029

Disconnect the crankshaft position sensor connector.


b.
A277030

Remove the bolt and crankshaft position sensor from the timing chain cover assembly.

NOTICE:

If a component has been dropped or subjected to a strong impact, replace the crankshaft position sensor.