Home › Engine / Hybrid System › 1NR-FE ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR › from 2016.04
RM30M0E _51 Engine / Hybrid System _053310 1NR-FE ENGINE CONTROL _0260023 ENGINE COOLANT TEMPERATURE SENSOR G

1NR-FE ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  INSPECTION  


PROCEDURE

Hide 89422 1.INSPECT ENGINE COOLANT TEMPERATURE SENSOR

a.

Check the resistance.

i.
A301191C01
0.094,0.083 0.406,0.281 0.313,0.198 10 false *a
*a Component without harness connected
(Engine Coolant Temperature Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Approximately 20°C (68°F) 2.32 to 2.59 kΩ
Approximately 80°C (176°F) 0.310 to 0.326 kΩ


CAUTION:

Make sure not to burn yourself.


NOTICE:
·

When checking the engine coolant temperature sensor in water, keep the terminals dry.

·

After the check, wipe the engine coolant temperature sensor dry.



If the result is not as specified, replace the engine coolant temperature sensor.