Home › Engine / Hybrid System › 1NR-FE ENGINE CONTROL › KNOCK SENSOR › from 2016.04
RM30M0E _51 Engine / Hybrid System _053310 1NR-FE ENGINE CONTROL _0260024 KNOCK SENSOR G

1NR-FE ENGINE CONTROL  KNOCK SENSOR  INSPECTION  


PROCEDURE

Hide 89615 1.INSPECT KNOCK SENSOR

a.

Check the resistance.

i.
A171218C01
1.865,1.063 2.219,0.385 true 1.542,1.052 1.208,0.427 true 0.125,0.104 0.438,0.26 0.313,0.156 10 false *a 2.292,0.292 2.844,0.521 0.552,0.229 10 false EKNK 0.792,0.344 1.344,0.573 0.552,0.229 10 false KNK1
*a Component without harness connected
(Knock Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (EKNK) - 2 (KNK1) 25°C (77°F) 120 to 280 kΩ


If the result is not as specified, replace the knock sensor.