Home › Engine / Hybrid System › 1NR-FE ENGINE CONTROL › VACUUM SENSOR › from 2016.04
RM30M0E _51 Engine / Hybrid System _053310 1NR-FE ENGINE CONTROL _0260025 VACUUM SENSOR G

1NR-FE ENGINE CONTROL  VACUUM SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89420H 1.INSPECT VACUUM SENSOR ASSEMBLY

a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Start the engine and warm it up until the engine coolant temperature reaches 75°C (167°F) or higher.


e.

Stop the engine. (*1)


f.

Turn the ignition switch to ON. (*2)


g.

Turn the GTS on. (*3)


h.

Enter the following menus: Powertrain / Engine and ECT / Data List / Brake Boost Pressure Sensor. (*4)

Powertrain > Engine and ECT > Data List
Tester Display
Brake Boost Pressure Sensor
50003 234 1087

i.

Depress the brake pedal 5 times and read the changes in the following pressure value.

Standard:
GTS Display Condition Specified Condition
Brake Boost Pressure Sensor
·

Ignition switch ON

·

Brake pedal depressed 5 times


Changes by 0.6 V or higher


NOTICE:

If the pressure inside the brake booster is high before performing the brake pedal operation procedure, it becomes difficult to cause changes in the pressure values before and after brake pedal operation, so avoid depressing the brake pedal as much as possible during steps (*1) to (*4).